The Amphenol 75160-132-24LF is a 24-position unshrouded male pin header from the BERGSTIK® series, built for board-to-board stacking or wire-to-board connections when paired with a mating receptacle. It uses a single row of square pins on a 0.100" (2.54 mm) pitch — a standard footprint that routes easily on a 0.062" board and leaves room for a trace between pads. The through-hole solder termination gives a solid mechanical anchor for the board edge or mid-board position. Rated 5 A per contact at 110 V, with a -65°C to 130°C operating range, this header handles general-purpose signal and moderate power duty. The 30.0 µinch gold GXT™ plating on the mating surface delivers the mating cycle life and corrosion resistance needed for repeated connect-disconnect in industrial or test equipment — gold on the interface, not just a flash, so the contact resistance stays stable over hundreds of cycles. The UL94 V-0 thermoplastic housing suits equipment inside an enclosure requiring flame rating.
Board layout and footprint fit
For the board layout engineer: the 0.100" pitch and single-row layout keep the board footprint narrow — 24 holes on 2.54 mm centres. The 0.120" (3.05 mm) solder tail length gives enough stand-off for wave solder or hand solder without bridging. The 0.100" (2.54 mm) insulation height above the board leaves clearance for traces under the body.
Sourcing and lifecycle
The 75160-132-24LF carries an Active lifecycle status from Amphenol — full production, no end-of-life notice. No official cross-reference or direct replacement is on record, but the BERGSTIK series includes many 24-position single-row headers — confirm the plating grade and tail length match your BOM before substituting.