Board-to-Board Header, 2 Positions, Dual-Row
It uses a 0.100" (2.54mm) pitch on both the row spacing and the pin-to-pin axis, matching the standard 0.100" grid for prototyping and production layouts.
The 110 V voltage rating is adequate for low-voltage logic and control signals; for anything above that, check the creepage distance across the unshrouded pins.
Mounting and Mechanical Notes
Through-hole mounting with a 0.110" (2.79 mm) post length — the solder tail is short enough for a standard 1.6 mm PCB without bottom-side clearance issues. The overall contact length of 0.530" (13.46 mm) gives a 0.320" (8.13 mm) mating pin length, which is enough to engage a standard box-header receptacle fully. The UL94 V-0 black insulation housing is flame-rated for equipment inside an enclosure. No board locks or alignment posts — the retention relies entirely on the solder joints, so the board needs to be supported against cable strain if this header sees a wire-to-board harness.