The Amphenol FCI 92417-122HLF is a 22-position, dual-row unshrouded male pin header from the BERGSTIK® II series, built on the industry-standard 0.100" (2.54 mm) pitch. This is a through-hole, push-pull style header with all positions loaded, intended for board-to-board interconnect where a low-profile, unshrouded pin strip mates with a standard IDC or crimp receptacle. The 0.100" pitch and dual-row layout give you 11 pins per row, matching the footprint of common ribbon cable connectors and prototyping grids.
The 5 A per-circuit current rating and 110 V voltage rating place this header firmly in signal-level duty — think logic lines, low-power sensor interfaces, or control signals, not a main power rail. The 30.0 µ" (0.76 µm) gold plating on the mating surface gives you a solid margin above the 15 µ" minimum for repeated mating cycles and mildly corrosive environments; if your application sees frequent board swaps or lives in an industrial cabinet, this plating grade handles it without the contact resistance drift you'd get from tin. The 0.100" insulation height and 0.320" mating pin length leave the pin tips exposed for a standard IDC receptacle or crimp housing. Overall contact length is 0.530" (13.46 mm), with a 0.110" solder post.
For a positive lock in vibration environments, look at the shrouded BERGSTIK variants. Termination is through-hole solder; the square pins (0.025" typical) are compatible with wave or hand soldering.