The 92634-160HLF is a 60-position, dual-row unshrouded header from the BergStik® II series by Amphenol ICC (formerly FCI). It uses the standard 0.100" (2.54mm) square grid pitch — matching legacy DIP footprints and breadboard layouts — with a right-angle through-hole termination that routes the pin tails parallel to the board surface. The 60 circuits are fully loaded across two rows, each contact carrying a 5A rating with 30.0µin (0.76µm) gold plating on the mating surface for sustained cycle life in moderate-duty signal interconnects.
What the ratings mean for the fit
The 0.100" pitch and 0.100" row spacing define a 10-column by 2-row footprint — a straight drop-in for any BergStik-compatible receptacle or IDC socket on the same grid. The 5A per-contact rating is typical for signal-level headers; at 60 positions fully loaded the total current through the connector is limited by the temperature rise of the housing and the PCB trace capacity, not the contact itself. The 30.0µin gold finish on the mating side gives the header a solid mating cycle life for field-service or repeated connect/disconnect — tin contacts at this pitch would wear faster under the same duty. Unshrouded means the pins are exposed with no plastic alignment wall — the mating receptacle or socket must provide the polarization and keying. This makes the header easy to probe during test but offers no mis-mate protection in a blind-mate assembly. The right-angle orientation places the pin tails at 90° to the mating axis, so the connector sits flush against the board edge and the cable exits parallel to the PCB plane — useful in space-constrained enclosures where vertical clearance is tight.