The Amphenol FCI 92634-432HLF is a 32-position, dual-row BergStik® II unshrouded male header on 0.100" (2.54 mm) pitch — the standard DIP-compatible grid that matches legacy perfboard, 0.100" header strips, and most IDC socket footprints. It's a board-to-board interconnect, through-hole mounted at a right angle, so the pins run parallel to the PCB surface. That right-angle orientation is the main thing: it puts the mating face at the board edge, saving Z-height inside a tight enclosure. The tin plating is 100.0 µ" (2.54 µm) thick on the mating side.
The 0.100" pitch and 0.100" row spacing match a standard 0.100" grid. The 0.318" (8.08 mm) mating pin length and 0.318" (8.08 mm) post length are specified.
This is a board-to-board header — it mates with a BergStik II female socket or any standard 0.100" pitch IDC receptacle. The unshrouded design means there's no polarisation key or latch; alignment depends on the mating socket's own features. That's fine for a mezzanine stack or a right-angle board-to-board link inside a fixed assembly, but I wouldn't spec it for a cable harness that gets yanked. The push-pull fastening type is just the friction of the pin-to-socket interference — no lock, no ramp. Typical use: a right-angle male header on a controller board, mating to a vertical female socket on a mezzanine card. The dual-row 32-position density is common for parallel data buses.