Right-Angle SMT Header for Board-to-Wire Routing
The 95000-004TRLF: The shrouded 1-wall design and latch holder fastening give the mating receptacle a positive click lock, holding against vibration and cable tug. A board guide and keying slot aid alignment during SMT placement and prevent cross-mating with non-keyed receptacles.
Sizing the Footprint and Mating Height
The 2.00mm pitch sets the board footprint: each pin centre is 2.00mm apart, matching standard 2mm IDC ribbon cable connectors. The square male pin (Copper Alloy) provides a reliable gas-tight interface when crimped into the matching Minitek receptacle terminal.
The 95000-004TRLF is the 4-position version. The 3-position sibling (95000-003TRLF) shares the same 2.00mm pitch, GXT gold plating, right-angle SMT form factor, and 2 A rating — only the circuit count differs. If your BOM calls for 3 circuits, that part is a drop-in for the same footprint width. For through-hole assembly, the 95000-004LF offers the same 4 positions and 2.00mm pitch in a bulk-packaged, solder-tail version — same GXT gold mating finish, same UL94 V-0 housing. The TRLF suffix on this part signals Tape & Reel packaging for automated placement.