The 112335: Rated to 4 GHz and 500 V, with a weatherproof seal that keeps moisture out of the connection in outdoor or damp enclosure runs.
What's in the Kit — Field-Termination Ready
This is a 9-piece field-install kit: the connector body, a centre contact, a clamp, a gasket, two insulators, a nut, a ring, and a washer. That's everything needed to terminate a cable on-site — no separate hardware order. The clamp-style shield termination and solder centre contact are standard for BNC field terminations; the gasket and insulators are what give it the weatherproof seal. Compare that to the 112133, which ships as a 4-piece kit (connector, contact, ferrule, sleeve) with no gasket or insulators — that one is a crimp termination for indoor RG-179 runs, not a weatherproof field kit.
Cable Compatibility — RG-59 and Beyond
The cable group covers RG-59, 59B, 62, 140, 210, plus Belden 8241, 8263, 8279, and 9209. RG-59 is the most common — it's the 75 Ohm coax used for analog video, CCTV, and older cable TV drops. If you're terminating a surveillance camera cable or a composite video run, this is the plug. The clamp shield termination grips the braid firmly; the solder centre pin makes a gas-tight connection to the centre conductor.
Mating Cycles and Field Duty
Rated for 500 mating cycles — that's a solid number for a BNC that might get disconnected and reconnected a few times during camera installation or maintenance. The weatherproof rating means the connection stays sealed when mated, so no water ingress into the cable end.
