What This BNC Jack Kit Includes and Where It Fits
Rated for 500 mating cycles, so it handles regular reconnection in a lab or production test fixture without the gold plating wearing through.
The cable group is RG-402 (.141" semi-rigid), so the centre conductor and dielectric dimensions are matched to the connector's PTFE insulator. The contact termination is solder — you tin the centre conductor and flow solder through the hole in the contact pin. No crimp tool needed, but the solder joint must be clean to keep the impedance transition from reflecting at the interface.
Mounting and Hardware
Mounts through a panel cutout with the bulkhead front-side nut — the connector body passes through from the outside, and the hex nut and lockwasher clamp it from behind. The gasket seals the panel interface against dust and splash, though there is no IP rating stated. Body is nickel-plated brass; the housing colour is gold (the nickel gives the gold a warm tone). The centre contact is gold-over-nickel on phosphor bronze — the gold handles the 500-cycle mating life, and the phosphor bronze spring keeps contact force consistent over temperature swings in an unheated equipment room.
The 112581 shares the same 50 Ohm, 4 GHz, 500-cycle, 500 V rating as the 112553 and 112536. The difference is the housing colour — gold on the 112581 versus silver on the 112553 and 112536 — and the packaging: the 112581 ships in a bag, while the 112536 ships in a tray. The 112553 also ships in a bag and is silver. Otherwise the electrical and mechanical performance is identical across all three.
