75 Ohm TNC Barrel for In-Line Signal Routing
The Amphenol RF 122351 is a TNC to TNC adapter — a straight plug-to-plug barrel that joins two male TNC connectors end-to-end. It's a same-series adapter, meaning both ends are TNC, so it extends a cable run or couples two cable assemblies without changing the interface. The body is free-hanging (in-line), threaded on both ends, and built for a 75 Ohm system — not the 50 Ohm you see on most TNC gear, so check your cable and equipment impedance before you commit. Rated to 1 GHz, this adapter handles the typical CATV, broadcast video, and telecom signal bands where 75 Ohm is standard. The nickel-plated brass body and gold-plated brass center contacts keep the signal path clean and resist corrosion in indoor or protected outdoor racks.
What the 75 Ohm Rating Means on the Bench
75 Ohm TNC adapters are less common than 50 Ohm — most TNC hardware is built for 50 Ohm RF systems (cellular, Wi-Fi, two-way radio). The 122351 is specced for 75 Ohm, which means the center conductor and dielectric geometry are sized for that impedance. If you drop this into a 50 Ohm line, you'll get a mismatch bump at the adapter, which eats into your return loss budget. Keep it in a 75 Ohm path — CATV headend, video distribution, or any broadcast-grade coax — and it behaves as a straight pass-through.
Male or Female? Both Ends Are Male Pin
Both ends of the 122351 are TNC plug, male pin — center gender is male-to-male. So it mates with two TNC jacks (female) on your cables or bulkhead connectors. If you need a female-to-female or male-to-female barrel, this isn't it. The threaded fastening on both sides means you wrench it down finger-tight plus a quarter turn with a 11/16-inch hex — no torque spec to chase, just snug.
