SMA Panel-Mount Jack for Field Termination
The 132121: The crimp shield termination and solder center contact make it practical for field or bench assembly on small-diameter coax like RG-174, RG-188, RG-316, and LMR-100. Rated to 12.4 GHz, it covers Wi-Fi, ISM bands, GPS, and most comms links up to that ceiling. The gold body finish and gold-plated beryllium copper center contact hold up to 500 mating cycles in weatherproof outdoor installations.
This SMA jack is built for RG-174, RG-188, RG-188A, RG-316, LMR-100, and M17/119-RG174 — the standard thin flexible coax used in patch cables, pigtails, and short antenna leads. The shield is crimped, the center conductor soldered. The kit includes a ferrule and heat shrink to seal the cable entry, which works with the weatherproof rating to keep moisture out of the interface. For semi-rigid cables like RG-402 or RG-405, look at the 132102 or 132111 plugs in the same series — those use solder shield termination instead of crimp.
What the 12.4 GHz Ceiling Means
Standard SMA connectors are typically rated to 18 GHz, but the 132121 is specified to 12.4 GHz. That's not a flaw — it's the trade-off for using a crimp shield termination, which is faster to install in the field than a solder shield but introduces a small impedance bump at higher frequencies. For applications below 12.4 GHz — 5G sub-6, Wi-Fi 6E, ISM, GPS /L2, and most two-way radio bands — this connector performs identically to a full 18 GHz part. If you need the full SMA bandwidth up to 18 GHz, the 132102 or 132111 plugs in the same series are rated there, but those use solder shield termination and require a different cable prep.
