Skip to main content
Amphenol 132357-11

Amphenol RF 132357-11 SMA Receptacle, 50 Ohm, 18 GHz

MPN 132357-11
Active

Amphenol RF SMA receptacle, female socket, 50 Ohm, 18 GHz, 1 port, board edge end launch, gold brass body, solder tab termination, PTFE dielectric, 500 mating cycles.

$11.3600 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Jul 2026

Specifications

132357-11 specifications
ParameterValue
MountingBoard Edge, End Launch
Connector typeReceptacle, Female Socket
Fastening typeThreaded
Frequency - max18 GHz
Operating temperature-65°C~165°C
Body materialBrass
Housing colorGold
Dielectric materialPolytetrafluoroethylene (PTFE)
Center contact materialBeryllium Copper
PackageBulk
Impedance50Ohm
Body finishGold
Mating cycles500
Number of ports1
Shield terminationSolder
Contact terminationSolder Tab
Center contact platingGold

Product details

Board Edge SMA Launch — 50 Ohm, 18 GHz

The Amphenol RF 132357-11 is an SMA receptacle (female socket) designed for board edge, end launch mounting — the signal pin aligns directly with a microstrip or coplanar waveguide trace at the PCB edge, keeping the 50 Ohm impedance path clean through the transition. Rated to 18 GHz with a PTFE dielectric, this connector is built for RF test points, microwave modules, and compact radio front-ends where a traditional right-angle or bulkhead SMA would add an unnecessary stub.

End Launch Footprint — What It Changes on the Board

Unlike a right-angle SMA that routes the signal through a 90° bend inside the connector, the end launch preserves the 50 Ohm reference plane with minimal discontinuity — important when the 18 GHz upper limit is in play. The threaded fastening type (M4 x 0.7 thread, standard SMA interface) mates with any SMA male plug. Because the connector is not panel-mounted, the mechanical retention relies on the solder joints and the mating nut torque — the board edge must be reinforced if the cable is frequently disconnected under tension.

MPN
132357-11