Skip to main content
TE Connectivity AMP Connectors 745253-7

TE Connectivity 745253-7 AMPLIMITE HDP-20 Socket Contact

MPN 745253-7
Active

TE Connectivity AMPLIMITE HDP-20 series, stamped socket contact, 745253-7, crimp termination, 22-26 AWG, gold flash finish, phosphor bronze, bulk.

$0.7700 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

745253-7 specifications
ParameterValue
TypeStamped
SeriesAMPLIMITE HDP-20
Wire gauge22-26 AWG
Contact materialPhosphor Bronze
PackageBulk
Pin or socketSocket
Contact finishGold
Contact terminationCrimp
Contact finish thicknessFlash

Product details

Stamped socket contact for AMPLIMITE HDP-20 harnesses

It's the female half of the D-sub signal connection — mates with the corresponding pin contact in a standard HDP-20 housing. The contact is formed from phosphor bronze with a gold flash finish, which gives it decent corrosion resistance and a reasonable number of mating cycles for a field-serviceable connector. If you're re-pinning an existing HDP-20 harness on site, this is the socket you drop in with a standard crimp tool.

Rated for 22-26 AWG, this socket accepts the wire sizes you'd typically run in a D-sub signal harness — think control wiring, serial lines, or sensor loops. The crimp barrel is stamped and formed, so it's a one-piece design that grabs the conductor and insulation in a single crimp. No separate sleeve to lose on the truck floor.

The gold flash (a thin layer, not a heavy plating) on phosphor bronze keeps the contact resistance low at first mate and protects against mild oxidation in indoor or controlled environments. It's not built for thousands of mating cycles or salt-spray exposure — that would call for a thicker gold plate. For typical industrial panel or equipment interconnects where the connector gets mated a few dozen times over its life, this finish is adequate. The phosphor bronze base gives the contact beam good spring retention, so it won't take a set after a few insertions.

MPN
745253-7