Stamped Pin for Multimate III+ Housings, 31.5µin Gold
It accepts 20-24 AWG wire and carries a gold plating at 31.5µin (0.80µm) on brass base material — the heavy gold layer is the key differentiator here, sized for repeated mating cycles and environments where tin would fret or corrode. This is a crimp-termination contact, not a solder cup, so the wire is cold-welded into the barrel with the proper die set.
The 20-24 AWG range covers the common signal and low-power wire sizes in a harness. At the 20 AWG end the pin carries the full rated current of the contact system; at 24 AWG the wire itself becomes the bottleneck. The brass body stamps cleanly without cracking the barrel during crimp — the material choice keeps the contact ductile enough for the crimp die to form a gas-tight joint.
Multimate III+ Housing Compatibility
This pin mates into any Multimate III+ receptacle or plug housing that accepts a stamped pin contact. The Multimate III+ system is a modular rectangular connector family used in industrial controls, power distribution, and rail applications — the stamped pin is the standard signal/power contact option. No special adapter or conversion is needed; it drops into the same cavity as the machined pin, though the stamped version is the cost-optimized choice for high-volume harness builds.