Skip to main content
TE Connectivity AMP Connectors 2834055-2

TE Connectivity 2834055-2 LIGHT-N-LOK Receptacle

MPN 2834055-2
Active

TE Connectivity LIGHT-N-LOK receptacle, 3 positions, 16-22 AWG, Poke-In termination, Tin contacts, 3A/8A, 600V, Free Hanging, Latch Holder, -40°C to 105°C.

$0.5600 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

2834055-2 specifications
ParameterValue
SeriesLIGHT-N-LOK
MountingFree Hanging (In-Line)
Connector typeReceptacle
Fastening typeLatch Holder
Voltage rating600V
Current rating3A, 8A
Wire gauge16-22 AWG
Operating temperature-40°C ~ 105°C
Housing colorBlack
Contact materialCopper Alloy
Housing materialThermoplastic
StyleCable/Wire to Cable/Wire
PackageBulk
TerminationPoke-In
Mating cycles10
Contact finishTin
Positions3

Product details

Sizing the Wire to the Current — the 3A vs 8A Trap

The TE Connectivity 2834055-2 is a 3-circuit LIGHT-N-LOK receptacle for Cable/Wire to Cable/Wire interconnects. It carries a dual current rating — 3A or 8A per circuit — and the figure that applies depends entirely on the wire gauge you land on. At 22 AWG the contact is good for 3A; step up to 16 AWG and the same contact body carries 8A. The poke-in termination accepts the full 16-22 AWG range, so the current limit is set by the wire, not the connector. The latch holder gives a positive lock — the housing won't walk loose under vibration the way a friction-fit would.

Poke-in termination means stripped solid or stranded wire pushes directly into the contact beam — no crimp tool, no separate terminal. The trade-off is insertion force: the beam grip that holds the wire also resists entry, so the wire strip length and the insertion tool (if used) matter more on the line than a crimp station. Tin-plated copper alloy contacts; the tin finish is fine for the 10 mating cycles the connector is rated for — this is a permanent-install part, not a field-service disconnect.

Mating Half — What Locks Into This Receptacle

This is the receptacle side of the LIGHT-N-LOK system. It mates with the corresponding LIGHT-N-LOK plug housing (same series, same latch-holder fastening). The 3-position count is fixed; the mating plug must also be 3 circuits. No keying or polarization on the basic housing, so the harness assembly needs to manage orientation at the bundle level.

MPN
2834055-2