Skip to main content
TE Connectivity AMP Connectors 5222420-1

TE 5222420-1 BNC Jack, 50 Ohm, 4 GHz, Through Hole, Active

MPN 5222420-1
Active

TE Connectivity 5222420-1 BNC jack, female socket, 50 Ohms, 4 GHz, 500 V, through-hole, solder termination, silver-plated center contact, bulk.

$9.8500 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for stock & sourcing questions
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent supplier — new & surplus connector stock· Listing updated Aug 2026

Specifications

5222420-1 specifications
ParameterValue
MountingThrough Hole
Connector typeJack, Female Socket
Fastening typeBayonet Lock
Voltage rating500 V
Frequency - max4 GHz
Operating temperature-55°C ~ 85°C
Body materialBrass
Housing colorSilver
Dielectric materialPolyester
Center contact materialPhosphor Bronze
PackageBulk
Impedance50 Ohms
Body finishNickel
Mating cycles500
Number of ports1
Shield terminationSolder
Contact terminationSolder
Center contact platingSilver

Product details

The through-hole solder termination means the centre contact and shield legs go into plated holes on the PCB, giving a mechanically solid joint that holds up to repeated cable strain. Silver plating on the centre contact and nickel on the brass body keep signal loss low across the 4 GHz bandwidth.

Rated for 500 mating cycles, which is the standard endurance for a bayonet-lock BNC — the coupling nut and detent wear before the centre contact does. The 500 V rating is the dielectric withstand between centre and shield; in practice, this connector lives on 50 Ohm lines carrying a few volts of RF or video signal, so the voltage headroom is generous.

Termination and Mounting

Both the centre contact and the shield are solder-terminated — no crimp tool needed, just a soldering iron and the right hole pattern on the board. The shield termination is soldered to the PCB ground plane through the four legs, which also provide the mechanical retention. The dielectric material is polyester, which holds the centre contact concentric to the outer conductor to maintain the 50 Ohm impedance through the joint.

No official cross-reference or second-source is listed on record, so the BOM line should stick with this TE part number unless a direct replacement is verified.

MPN
5222420-1