The JST GHR-13V-S is a 13-position single-row receptacle housing from the GH series, on a 1.25mm pitch. This is a wire-to-board interconnect family, typically used in compact consumer electronics, industrial sensors, and appliance harnesses where the 1.25mm pitch saves board space while still allowing a manual assembly process.
For the GH series, the compatible contacts are JST part numbers SSH-003T-P0.2 (tin-plated, for 24-28 AWG) or SSH-003GA-P0.2 (gold-plated, for higher mating cycle requirements). Order 13 contacts per housing, plus spares for the crimp press setup. The housing accepts the contacts from the rear and the latch lock holds them in place — no secondary retainer is needed on this series.
Mating Half and Harness Fit
The 1.25mm pitch and latch lock are consistent across the GH family — any 13-position GH header with the same latch geometry will mate. For a complete harness, you need: one GHR-13V-S housing, 13 SSH-series crimp terminals, and the mating board-side header. Stock both halves or neither — an orphan housing with no mated header on the shelf is dead stock.