Board-fit anchor: 0.100" pitch, 4 positions, single row
The 1379165-7: The 4-position single-row layout matches low-circuit-count signal or power taps in automotive and industrial control harnesses. Tin-plated male pins (copper alloy) handle moderate mating cycles — typical for connections mated once at assembly and rarely cycled in service. The 0.232" (5.90mm) mating length provides a solid wipe for the receptacle contact.
12 V rating and shrouded housing
Rated 12 V, this header is suited for low-voltage DC circuits — common in automotive body electronics, infotainment, and sensor interfaces where the bus runs at 12 V nominal.
This header mates with Micro Quadlok receptacle housings that accept 0.63mm tab terminals — the same 0.63mm contact system used across the series. The push-pull fastening provides a positive latch engagement audible on mating. Through-hole solder termination suits hand or wave-solder assembly. The 0.150" (3.81mm) post length fits standard 1.6mm PCBs with enough protrusion for a reliable solder fillet.
That part adds a right-angle orientation and a second row — useful when board-edge space is tight or more circuits are needed. For a 4-position single-row job, 1379165-7 is the direct fit.