2-Position Housing at 5.08 mm — the BOM Line Match
The housing is free-hanging (inline), so no PCB footprint is involved; this is a wire-to-wire or wire-to-device interconnect. Contacts are not included — the buyer orders the crimp sockets separately. That is the single most common trip-up on this part: the housing arrives empty, and the build stops if the matching terminal isn't on the BOM. The Dynamic D-3500 uses a specific female socket contact (TE part family 175362 is the housing side; the terminal is a separate line item).
What Mates and What Fills It
Mating half is the Dynamic D-3500 series pin header — a 2-position, 5.08 mm pitch header that locks into this receptacle. No header order code is listed in the spec sheet, but the series designation and pitch confirm the mate. The crimp terminal is a female socket, TE part number series 1-175362 (verify the exact wire gauge variant against your harness build). The housing accepts the terminal, which is then crimped onto the wire and inserted from the rear until the latch seats.