22-Position Plug Housing for Wire-to-Board Harnesses
This black polyamide (PA66) housing carries a 0.118" (3.00mm) pitch in a dual-row layout, mates with the corresponding Micro MATE-N-LOK header, and secures the interface with a locking ramp.
The locking ramp on this plug housing provides an audible and tactile latch when mated with the header, resisting vibration-induced separation in equipment like HVAC controllers or automotive body modules. The panel mount, snap-in feature allows the housing to be secured into a panel cutout before the harness is dressed, simplifying assembly in enclosures where the connector must stay fixed while the mating half is plugged in. The 3.00mm pitch gives adequate creepage for the 600V rating typical of the Micro MATE-N-LOK series, matching the board footprint of the header without requiring an oversized PCB layout.
At 22 positions, this housing sits between the 20-position 2-794615-0 and the 24-position 2-794615-4 in the same Micro MATE-N-LOK series, all sharing the 0.118" (3.00mm) pitch, dual-row layout, locking ramp, and panel-mount snap-in.
Contacts Are Sold Separately — Plan the Full BOM
The listing note states contacts are not included. For a build-to-print harness, the full BOM requires the housing, the correct number of terminals, and the mating header or receptacle. The 2-794616-2 is a free-hanging (in-line) version of this same 22-position plug housing if panel mounting is not needed.