4-Position Panel-Mount Plug Housing at 5.00mm Pitch
The housing is molded in gray PBT, a material that holds up to underhood temperatures and resists common workshop fluids.
Mounting and Mating — Snap-In Panel Fit with Latch Holder
This housing mounts via panel snap-in, meaning it clips into a rectangular cutout without hardware — handy for a bulkhead pass-through where you want the connector fixed and the cable side free to disconnect. The 5.00mm pitch means the mating receptacle must match that spacing — confirm your counterpart has the same 0.197" centerline.
The key procurement detail: contacts are not included, so budget for the matching crimp tab terminals when you place the RFQ.
