3-Position Signal Header with Latch Holder
The 4-2232826-3 is a 3-position, single-row header from the Grace Inertia 2.0 series, designed for board-to-cable/wire connections. Tin plating is cost-effective for moderate mating cycles — expect hundreds of mates before wear-through, not thousands. The 2 A ceiling is the per-contact limit at room ambient; derate above 85°C per the series curve.
Through-Hole Termination and Housing
Through-hole mounting with kinked pins — the kink provides a press-fit retention in the plated hole before soldering, holding the header in place during wave solder.
Mating Half and Series Fit
This header mates with Grace Inertia 2.0 receptacle housings (cable side) that accept the matching crimp terminals. The latch holder on the header engages the receptacle latch for a positive lock — no secondary fastener needed. Confirm the receptacle part number against the 3-circuit, 2.00 mm pitch, single-row configuration before ordering.