The F300-1B7H1-11032-E100: The right-angle SMT orientation and 2.00 mm height above board make it a fit for board-edge routing where z-height is tight — the connector body sits low, leaving room for a parallel PCB or enclosure wall. Gold-plated contacts at 1.97 µinch thickness are rated for 30 mating cycles. That is a single-mate or infrequent-service duty — field-service reconnects are not the design target.
ZIF Flip Lock and Solder Retention for Vibration Resistance
The flip-lock actuator secures the FFC or FPC without insertion force — the contact beam wipes the pad on closure. Solder retention pads on the SMT tails anchor the connector against shear from cable strain. Accepts 0.20 mm thick FFC with a notched cable end — the contact geometry is bottom-contact, so the cable inserts with the exposed pads facing down.
No pin-compatible replacement or successor listed from Amphenol ICC (FCI) — this is the current part number for the Aorora F300 series at 32 positions.