6-Position, 0.50mm Pitch, Right-Angle SMT FPC Connector
The 59453-061110ECHLF is a 6-position, 0.50mm pitch FPC connector from Amphenol ICC (FCI)'s SFVL series. It uses a bottom-contact, zero-insertion-force (ZIF) design with a slide lock actuator — the FPC inserts without force, then the slide locks it in place. Right-angle SMT mounting keeps the profile at 0.88mm above the board, which suits tight z-height budgets in portable or embedded designs.
0.4A Signal-Duty Rating and 10 Mating Cycles
Rated at 0.4A per contact and 50V, this connector is strictly for signal-level interconnects — not power delivery. The current ceiling is typical for 0.50mm-pitch FPC connectors, where the narrow contact beam and fine pitch limit ampacity. The 10 mating cycles mean this part is intended for one-time or infrequent disconnect applications; in a field-service scenario where the cable is cycled quarterly, the contact interface would wear out in under three years. Gold plating on the contacts helps maintain low resistance over those few cycles, but the cycle count itself is the limiting factor.
ZIF Slide Lock and Solder Retention
The ZIF mechanism means the FPC is inserted with the slide open, then the slide lock is pushed to clamp the cable — no insertion force on the contacts.
It is RoHS compliant.
Peer Comparison: 59453-061110EDHLF
The closest alternative is the 59453-061110EDHLF — same 6 positions, 0.50mm pitch, same height and ZIF slide lock. The difference is in the contact finish: the ECHLF uses gold, while the EDHLF likely uses a different plating (tin or selective gold). If your application requires higher mating cycle life or better corrosion resistance, the gold-plated ECHLF is the safer choice. For cost-sensitive, single-mate applications, the EDHLF may be an AVL alternate.