12-Position Sealed Plug Housing for Harness Builds
The 4.80mm pitch and 0.220" row spacing give each contact pair enough physical separation to maintain the seal integrity across the connector face.
Sealed for Wet or Dusty Duty
The sealed construction means the housing incorporates interfacial and wire-entry seals — not just a gasket on the mating face. That makes this plug a fit for under-hood harness sections, exposed sensor connections, or any location where splash, pressure wash, or road grime reaches the connector.
Contacts Are Ordered Separately — Don't Forget the Terminals
The listing note is explicit: contacts are not included. The housing ships as a bare shell with the PBT insulation and the latch holder. The crimp termination means the terminal is attached to the wire before insertion into the housing cavity, and the secondary lock in the housing retains it. Ordering the housing without the terminals is a common BOM miss; the pair must be on the same line.