SMA Jack for 26.5 GHz Microwave Paths
The 901-10512-3: The right-angle through-hole mounting with board edge end launch capability lets you place it at the PCB edge for a clean RF launch into a coaxial cable or test port. Threaded fastening gives a vibration-resistant mate that holds the interface impedance steady across the band.
That cycle count is typical for an SMA-class connector — the threaded coupling nut and gold-on-nickel centre contact wear gradually, and the 500-cycle rating gives a comfortable margin for most bench or rack applications before contact resistance drifts.
Mounting and Termination — Board Edge or Through-Hole
Two mounting options in one body: board edge end launch for a low-profile RF exit at the PCB perimeter, or through-hole right angle for a standard perpendicular mount. The shield and centre contact both terminate with solder — no crimp tool needed. The threaded coupling nut mates with any standard SMA plug; the 170 V voltage rating covers signal-level and low-power RF paths without derating concern.